Site-To-Site Vpn Configuration On Cisco Asa. Zindagi technologies has proven of an expert in the field of configuring remote vpn, site to site vpn, plain gre, or mpls vpn, vpn deployments. Even though it is more comfortable to configure this kind of stuff using the asdm gui, i thought it was a pretty good exercise to try to setup everything on the console.
Follow the steps shown below in the image. Now i’m going to create a “tunnel group” to tell the firewall it’s a site to site vpn tunnel “l2l”, and create a shared secret that will need to be entered at the other end of the site to site vpn tunnel. If you want to use vpn on your sites and to provide remote services.
In The Following Command, Inside Is Our Local Interface, 192.168.1.100 Is The Local Ip We're Testing Traffic From, 12345 Is The Source Port (It Can Be Anything You Choose), And 192.168.2.100 Is The Remote Ip We're Trying To Reach.
You configure both devices to setup a tunnel with each other. The whole remote office can now use this tunnel at the same time (whereas with remote access vpn only the. You place a vpn device like cisco asa or a cisco router on both sites.
Even Though It Is More Comfortable To Configure This Kind Of Stuff Using The Asdm Gui, I Thought It Was A Pretty Good Exercise To Try To Setup Everything On The Console.
Now i’m going to create a “tunnel group” to tell the firewall it’s a site to site vpn tunnel “l2l”, and create a shared secret that will need to be entered at the other end of the site to site vpn tunnel. However, the post will not cover any of the asa configuration parts, but please check out cisco documentation on this link if required. Remember that a cisco asa firewall is by default capable to support ipsec vpn but a cisco router must have the proper ios software type in order to support encrypted vpn tunnels.
Technology _ January 25, 2022 _ Zindagi Technologies.
Follow the steps shown below in the image. I have two firewalls fw1 and fw2 where fw1 = 192.168.1.0 and fw2 = 192.168.2.0. If you want to use vpn on your sites and to provide remote services.
I Used The Following Template For Fw1, And Obviously Switched The Configuration Around For Fw2.
In this first page fill in the name of virtual network and the. The connection uses a custom ipsec/ike policy with the usepolicybasedtrafficselectors option, as described in this article. Ensure the tunnel group name is the ip address of the firewall/device that the other end.
Configuring A Site To Site Vpn Tunnel On Palo Alto Firewalls Is Not Difficult, But It Could Be A Little Bit Challenging For The People Who Are Not Familiar With.
Cisco asa series vpn cli configuration guide, 9.8. The first site (remote1) is equipped with a cisco asa firewall (any model) and the second site (remote2) is equipped with a cisco router. Access the firewall using the username and password through asdm.