How To Take Link Out Of Watch. Most watches will have up to three pins that may be removed on each. Insert the pin pusher into the hole and push the pin firmly.
Lay the watchband upside down on a hard surface. Put the watch on the foam or the watch holder with the arrows facing downwards. Push the screwdriver into the opening.
By Using A Pin Pusher Place The Watch On The Table With The Push Pins Facing Up.
So a watch holder that holds the watch band, allows you to align the punch and hammer the pin through. Look for the arrow mark under the strap. You will notice the pin sliding out or shifting to the other end.
Put One End Of The Pin In The Inner Side Of One Hole Of The Link.
Just open the clasp with your fingers and take it off. Put the watch on and assess how many links need to be removed before it fits properly. Fit the watch strap inside the watch tool.
This Is The Tried And True Method.
Even after many years of use, you can generally. The end of the pin, where it is attached to the watch band, is slightly convex in order to help it stay in place. Then connect both sides of a band and push the clasp until you.
Repeat The Process Until The Band Fits Your Wrist.
Pry the edge of the band up to get to the small connecting piece. Lay the watchband upside down on a hard surface. Insert the pin pusher into the hole and push the pin firmly.
Once You’ve Pushed The Pin Enough, It Will Pop Out.
Once you have found the pin base, the rest of the pin is much easier to locate. Get the pin and push it inside the pin slot. If you have a hammer, you can use it to gently push the pin inside.